FUEL INJECTOR > REMOVAL |
| 1. PRECAUTION |
| 2. DISCHARGE FUEL SYSTEM PRESSURE |
| 3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 4. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY |
![]() |
Lift the rear of the engine cover to detach the cover from the 2 pins, and then lift the front of the engine cover to detach the cover from the pin and remove the engine cover.
| 5. REMOVE AIR CLEANER CAP SUB-ASSEMBLY |
![]() |
Disconnect the vacuum switching valve assembly from the air cleaner hose.
![]() |
Disconnect the mass air flow meter connector and 2 wire harness clamps from the air cleaner cap sub-assembly.
![]() |
Separate the fuel vapor feed hose from the air cleaner hose.
![]() |
Disconnect the ventilation hose from the cylinder head cover.
![]() |
Loosen the hose clamp and disconnect the air cleaner hose from the throttle with motor body assembly.
![]() |
Release the 2 clamps and remove the air cleaner cap sub-assembly.
| 6. DISCONNECT FUEL TUBE SUB-ASSEMBLY |
![]() |
Disengage the claw and remove the No. 1 fuel pipe clamp.
Disconnect the fuel tube sub-assembly from the fuel pipe.
![]() |
Pinch the retainer of the fuel tube connector, and then pull the fuel tube connector off of the fuel pipe.
| *a | Retainer |
| *b | O-ring |
| *c | Fuel Tube Connector |
| *d | Fuel Pipe |
| *e | Nylon Tube |
![]() | Pinch |
![]() | Pull |
If the fuel tube connector and fuel pipe are stuck, push and pull the fuel tube connector to release it. Pull the fuel tube connector off of the fuel pipe carefully.
Check if there is any foreign matter on the sealing surfaces of the disconnected fuel lines. Clean them if necessary.
Cover the disconnected fuel pipe and fuel tube connector with plastic bags to prevent damage and contamination.
Disengage the clamp to disconnect the fuel tube sub-assembly from the fuel hose clamp.
| 7. REMOVE VACUUM SWITCHING VALVE ASSEMBLY (for ACIS) |
![]() |
Disconnect the union to connector tube hose and wire harness clamp.
Disconnect the 2 vacuum hoses and connector.
Remove the bolt and vacuum switching valve assembly.
![]() |
Remove the bolt and vacuum hose clamp.
| 8. DISCONNECT WIRE HARNESS |
![]() |
Disconnect the 4 fuel injector assembly connectors, throttle body with motor assembly connector and sensor wire connector.
Remove the 2 bolts and separate the 2 wire harness brackets from the intake manifold.
Disengage the clamp to disconnect the wire harness.
| 9. REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY |
![]() |
Remove the 2 bolts and fuel delivery pipe sub-assembly with the 4 fuel injector assemblies.
![]() |
Remove the 2 fuel delivery spacers from the cylinder head.
| *1 | Fuel Delivery Spacer |
| *2 | Injector Vibration Insulator |
Remove the 4 injector vibration insulators from the cylinder head.
| 10. REMOVE FUEL INJECTOR ASSEMBLY |
![]() |
Pull the 4 fuel injector assemblies out of the fuel delivery pipe sub-assembly.
Remove the O-ring from each fuel injector assembly.
For reinstallation, attach a tag or label with the corresponding cylinder number to each fuel injector assembly.