REAR BRAKE > INSTALLATION |
| 1. INSTALL REAR DISC |
![]() |
Align the matchmarks of the rear disc and rear axle hub, and install the rear disc.
| *a | Matchmark |
| 2. INSTALL PARKING BRAKE SHOE ADJUSTING HOLE PLUG |
Install the parking brake shoe adjusting hole plug.
| 3. INSTALL DISC BRAKE CYLINDER MOUNTING |
![]() |
Install the disc brake cylinder mounting with the 2 bolts.
| 4. INSTALL REAR DISC BRAKE BUSHING DUST BOOT |
![]() |
Apply a light layer of lithium soap base glycol grease to the entire circumference of 2 new rear disc brake bushing dust boots.
![]() | Lithium Soap Base Glycol Grease |
![]() |
Install the 2 rear disc brake bushing dust boots to the disc brake cylinder mounting.
| 5. INSTALL REAR DISC BRAKE CYLINDER SLIDE BUSHING |
![]() |
Apply a light layer of lithium soap base glycol grease to the contact surface of the rear disc brake cylinder slide pin.
![]() | Lithium Soap Base Glycol Grease |
Install a new rear disc brake cylinder slide bushing to the rear disc brake cylinder slide pin.
| 6. INSTALL REAR DISC BRAKE CYLINDER SLIDE PIN (for Lower Side) |
![]() |
Apply a light layer of lithium soap base glycol grease to the sliding and sealing surfaces of the rear disc brake cylinder slide pin.
![]() | Lithium Soap Base Glycol Grease |
![]() |
Install the rear disc brake cylinder slide pin to the disc brake cylinder mounting.
Push the rear disc brake cylinder slide pin into the rear disc brake bushing dust boot to engage the pin to the boot.
| 7. INSTALL REAR DISC BRAKE CYLINDER SLIDE PIN (for Upper Side) |
![]() |
Apply a light layer of lithium soap base glycol grease to the sliding and sealing surfaces of the rear disc brake cylinder slide pin.
![]() | Lithium Soap Base Glycol Grease |
![]() |
Install the rear disc brake cylinder slide pin to the disc brake cylinder mounting.
Push the rear disc brake cylinder slide pin into the rear disc brake bushing dust boot to engage the pin to the boot.
| 8. INSTALL REAR DISC BRAKE PAD SUPPORT PLATE |
![]() |
Install the 2 rear disc brake pad support plates to the disc brake cylinder mounting.
| *1 | Rear Disc Brake Pad Support Plate |
| *2 | Disc Brake Cylinder Mounting |
| 9. INSTALL REAR DISC BRAKE ANTI-SQUEAL SHIM KIT |
![]() |
Install the pad wear indicator plate to each rear disc brake pad.
![]() |
Apply disc brake grease to the inside of the rear disc brake anti-squeal shims.
![]() | Disc Brake Grease |
![]() |
Install the rear disc brake anti-squeal shim to each rear disc brake pad with pad wear indicator plate.
| 10. INSTALL REAR DISC BRAKE PAD |
Install the 2 rear disc brake pads with rear disc brake anti-squeal shim kit to the disc brake cylinder mounting.
| 11. INSTALL REAR DISC BRAKE CYLINDER ASSEMBLY |
![]() |
Hold the rear disc brake cylinder slide pin, and install the rear disc brake cylinder assembly to the disc brake cylinder mounting with the 2 bolts.
| *a | Hold |
| *b | Turn |
| 12. CONNECT REAR FLEXIBLE HOSE |
![]() |
Connect the rear flexible hose to the rear disc brake cylinder assembly with a new union bolt and a new gasket.
| *a | Lock Hole |
| 13. BLEED BRAKE LINE |
| 14. ADJUST PARKING BRAKE |
| 15. INSTALL REAR WHEEL |