REAR BRAKE > INSPECTION |
| 1. INSPECT BRAKE CYLINDER AND PISTON |
Check the cylinder bore and piston for rust and scoring. If necessary, replace the rear disc brake cylinder assembly and/or piston.
| 2. INSPECT PAD LINING THICKNESS |
![]() |
Using a ruler, measure the pad lining thickness.
| *1 | Ruler |
| 3. INSPECT REAR DISC BRAKE PAD SUPPORT PLATE |
Make sure that the rear disc brake pad support plates have sufficient rebound, no deformation, cracks or wear, and that all rust and dirt are removed.
If necessary, replace the rear disc brake pad support plates.
| 4. INSPECT DISC THICKNESS |
![]() |
Using a micrometer, measure the disc thickness.
| *1 | Micrometer |
| 5. INSPECT DISC RUNOUT |
Inspect the rear axle hub bearing looseness and axle hub runout.
![]() |
While holding the disc using SST, tighten the disc with the 5 hub nuts.
![]() |
Using a dial indicator with magnetic base, measure the disc runout 10 mm (0.394 in.) away from the outer edge of the rear disc.
| *1 | Dial Indicator |
Remove the 5 nuts and rear disc.