SFI SYSTEM > Fuel Pump Control Circuit |

| 1.PERFORM ACTIVE TEST USING GTS (CONTROL THE FUEL PUMP / SPEED) |
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed.
Check whether the fuel pump operating sound occurs when performing the Active Test on the GTS.
| Result | Proceed to |
| Fuel pump operating sound does not occur | A |
| Fuel pump operating sound occurs | B |
|
| ||||
| A | |
| 2.CHECK HARNESS AND CONNECTOR (NO. 1 INTEGRATION RELAY - ECM) |
Remove the No. 1 integration relay from the engine room relay block and junction block assembly.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1E-1 - A25-21 (FC) | Always | Below 1 Ω |
| 1E-1 or A25-21 (FC) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (NO. 1 INTEGRATION RELAY - FUEL PUMP - BODY GROUND) |
Remove the No. 1 integration relay from the engine room relay block and junction block assembly.
Disconnect the fuel pump connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1C-6 - N11-4 (B) | Always | Below 1 Ω |
| N11-5 (E)- Body ground | Always | Below 1 Ω |
| 1C-6 or N11-4 (B) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.INSPECT FUEL PUMP |
Inspect the fuel pump (Click here for TMC made, Click here for TMMK made).
| Result | Proceed to |
| OK | A |
| NG (for TMC made) | B |
| NG (for TMMK made) | C |
|
| ||||
|
| ||||
| A | |
| 5.CHECK HARNESS AND CONNECTOR (BATTERY - NO. 1 INTEGRATION RELAY) |
Remove the No. 1 integration relay from the engine room relay block and junction block assembly.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1D-1 - Body ground | Always | 11 to 14 V |
|
| ||||
| OK | ||
| ||
| 6.READ VALUE USING GTS (STARTER SIGNAL) |
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Starter Signal.
Check the result when the ignition switch is ON and the engine starts.
| Ignition Switch Position | Starter Signal |
| ON | OFF |
| START | ON |
|
| ||||
| OK | |
| 7.READ VALUE USING GTS (ENGINE SPEED) |
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Engine Speed.
Read the values displayed on the GTS while cranking.
|
| ||||
| OK | ||
| ||