TIRE PRESSURE WARNING VALVE > INSTALLATION |
| 1. INSTALL TIRE PRESSURE WARNING VALVE AND TRANSMITTER |
Install a new grommet to the tire pressure warning valve and transmitter.
![]() |
Write down the 7-digit transmitter ID number shown in the illustration.
| *a | Printed Surface |
| *b | 7-digit Transmitter ID Number |
Insert the tire pressure warning valve and transmitter with grommet from the inside of the rim.
![]() |
Install the washer to the tire pressure warning valve and transmitter from the outside of the rim, and using an 11 mm socket wrench, tighten the nut.
| *1 | Tire Pressure Warning Valve and Transmitter |
| *2 | Grommet |
| *3 | Washer |
| *4 | Nut |
| *a | Rim |
![]() |
Set the tire and disc wheel to the mounting machine as shown in the illustration.
| *a | Rim |
| *b | Mount Tool of the Mounting Machine |
| *c | 60° |
![]() | Rim Rotating Direction |
![]() | Area for Tire Pressure Warning Valve and Transmitter |
Apply a sufficient coat of soapy water or equivalent to the tire bead and rim.
Using a mounting machine, install the tire to the disc wheel.
Install a new valve core.
Inflate the tire to the specified tire inflation pressure.
After the tire is inflated, the nut may be loose. Using an 11 mm socket wrench, retighten the nut to the specified torque.
Check the surroundings of the tire pressure warning valve and transmitter for air leaks with soapy water or equivalent.
If air is leaking from the valve core, press the valve core several times to remove foreign matter. Replace the valve core as necessary.
If air is leaking from around the tire pressure warning valve and transmitter, check if the grommet, washer and nut are not deformed, damaged or contaminated with foreign matter. Replace the grommet, washer or nut as necessary.
Install the tire valve cap.
| 2. INSTALL WHEEL ASSEMBLY |
| 3. INSTALL SPARE TIRE |
| 4. INSPECT TIRES |
Check the tires for wear and proper inflation pressure.
| Tire Size | Front kPa (kgf/cm2, psi) | Rear kPa (kgf/cm2, psi) |
| P215/55R17 93V | 210 (2.1, 30) | |
Perform initialization (Click here).
Tire pressure adjustment method when warm:
Turn the engine switch off.
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Chassis / Tire Pressure Monitor / Data List.
Adjust the tire pressure so that the displayed value is equal to the set pressure.
Perform initialization and check that initialization completes (Click here).
Check and record the value of the Data List item "Temperature in Tire". (Ts)
Check and record the ambient temperature during tire pressure adjustment. (Tm)
Readjust the tire pressure according to the difference between the tire internal temperature (Ts) and the ambient temperature (Tm). (P)
Check the pressure adjustment value with the Data List item "Tire Inflation Pressure".
![]() |
Using a dial indicator, check the runout of the tires.
| 5. REGISTER TRANSMITTER ID |
| 6. INSPECT TIRE PRESSURE WARNING SYSTEM |
| 7. PERFORM INITIALIZATION |