Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM (w/o Smart Entry and Start System)

DTC    B2780    Push Switch / Key Unlock Warning Switch Malfunction

for Preparation Click here


DESCRIPTION

This DTC is stored if the transponder key ECU assembly does not detect that the unlock warning switch assembly is ON even when the key is in the ignition key cylinder. Under normal conditions, the unlock warning switch assembly is ON when the key is in the ignition key cylinder.

DTC No.
DTC Detection Condition
Trouble Area
DTC Output Confirmation Operation
B2780
The unlock warning switch assembly is not detected as being on when the ignition switch is ON (1 trip detection logic*).
  1. Wire harness or connector
  2. Unlock warning switch assembly
  3. Transponder key ECU assembly
Insert the door control transmitter assembly into the ignition key cylinder.
  1. *: Only output while a malfunction is present.

Vehicle Condition and Fail-safe Operation when Malfunction Detected 
Vehicle Condition when Malfunction Detected
Fail-safe Operation when Malfunction Detected
Engine cannot be started
-

Related Data List and Active Test 
DTC No.
Data List and Active Test
B2780
Key SW

WIRING DIAGRAM


B278950E01


INSPECTION PROCEDURE

NOTICE:
  1. If the transponder key ECU assembly is replaced, refer to Service Bulletin.
  2. After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".

1.CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


2.CHECK FOR DTC
  1. Perform "DTC Output Confirmation Operation" procedure.

  1. Check for DTCs (Click here).

    OK:
    DTC B2780 is not output.

    Result:
    Result
    Proceed to
    DTC B2780 is output
    A
    DTC B2780 is not output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A


3.INSPECT UNLOCK WARNING SWITCH ASSEMBLY


    B203483E04
  1. Remove the unlock warning switch assembly (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Pushed
    (Key set)
    Below 1 Ω
    1 - 2
    Free
    (Key removed)
    10 kΩ or higher

    Text in Illustration 
    *a
    Component without harness connected
    (Unlock Warning Switch Assembly)
    *b
    Free
    *c
    Pushed



NG
REPLACE UNLOCK WARNING SWITCH ASSEMBLY (Click here)
OK


4.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU ASSEMBLY - UNLOCK WARNING SWITCH ASSEMBLY - BODY GROUND)
  1. Disconnect the I19 transponder key ECU assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I19-3 (KSW) - I33-1 (UN+)
    Always
    Below 1 Ω
    I19-3 (KSW) or I33-1 (UN+) - Body ground
    Always
    10 kΩ or higher
    I33-2 (UN-) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TRANSPONDER KEY ECU ASSEMBLY