UNLOCK WARNING SWITCH > REMOVAL |
| 1. PRECAUTION |
| 2. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD |
| 3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 4. REMOVE LOWER STEERING COLUMN COVER |
Release the tilt and telescopic lever, and fully extend and lower the steering column assembly.
Lock the tilt and telescopic lever.
![]() |
Turn the steering wheel assembly to the left and remove the screw.
![]() |
Turn the steering wheel assembly to the right and remove the screw.
![]() |
Push the right and left sides of the lower steering column cover to disengage the 2 claws.
![]() |
Insert your fingers into the opening of the tilt lever of the lower steering column cover to disengage the 2 claws.
| 5. REMOVE UPPER STEERING COLUMN COVER |
![]() |
Disengage the 4 clips and 2 guides to separate the instrument cluster finish panel assembly from the upper steering column cover.
![]() |
Disengage the 2 claws and remove the upper steering column cover.
| 6. REMOVE TRANSPONDER KEY COIL |
![]() |
Disengage the 2 claws and disconnect the transponder key coil.
![]() |
Disconnect the connector to remove the transponder key coil.
| 7. REMOVE IGNITION SWITCH LOCK CYLINDER ASSEMBLY |
![]() |
Turn the ignition switch lock cylinder assembly to the ACC position.
| *a | LOCK |
| *b | ACC |
![]() |
Insert a screwdriver into the hole of the steering column upper bracket assembly as shown in the illustration. Pull the ignition switch lock cylinder assembly until its claw contacts the stopper of the steering column upper bracket assembly.
| *1 | Claw |
| *2 | Stopper |
![]() | Push |
![]() | Pull |
![]() |
Insert a screwdriver into the hole of the steering column upper bracket assembly. Tilt the screwdriver as shown in the illustration to disengage the claw of the ignition switch lock cylinder assembly, and pull out the ignition switch lock cylinder assembly from the steering column upper bracket assembly.
| *1 | Claw |
| *2 | Stopper |
| *a | Claw disengaged |
| *b | Driver Insertion Hole |
![]() | Tilt |
![]() | Pull out |
| 8. REMOVE UNLOCK WARNING SWITCH ASSEMBLY |
Disconnect the connector.
![]() |
Remove the unlock warning switch assembly by pushing up the center part and releasing the 2 claws.
| *a | Center Part |