Home › Vehicle Interior › HEATING / AIR CONDITIONING › FRONT EVAPORATOR TEMPERATURE SENSOR (for TMMK Made)

FRONT EVAPORATOR TEMPERATURE SENSOR (for TMMK Made) > INSTALLATION

for Preparation Click here



1. INSTALL NO. 1 COOLER THERMISTOR


    E151029E05
  1. Install the No. 1 cooler thermistor as shown in the illustration.
    Text in Illustration 
    *a
    Fixed Part
    *b
    Sensor Part
    Part
    Length
    A
    34.3 mm
    1.35 in.
    B
    20.9 mm
    0.823 in.
    C
    50 mm
    1.97 in.

    NOTICE:
    1. Be sure to insert the No. 1 cooler thermistor only once because reinserting it into the same position will not allow it to be firmly secured.
    2. When reusing the No. 1 cooler evaporator sub-assembly, insert the No. 1 cooler thermistor one row next to the one that has been used previously (X in the illustration).
    3. After inserting the No. 1 cooler thermistor, do not apply excessive force to the wire.
    4. Directly insert the No. 1 cooler thermistor until the edge of the plastic case "a" comes into contact with the No. 1 cooler evaporator sub-assembly "b".

  1. Engage the 2 clamps.



2. INSTALL BLOWER ASSEMBLY WITH COOLER EVAPORATOR SUB-ASSEMBLY
(Click here)