DOOR CONTROL TRANSMITTER (w/o Smart Entry and Start System) > INSPECTION |
| 1. INSPECT DOOR CONTROL TRANSMITTER MODULE SET SUB-ASSEMBLY |
Inspect operation of the door control transmitter module set sub-assembly. (Type A)
Remove the transmitter battery from the door control transmitter module set sub-assembly (Click here).
![]() |
Install a new or non-depleted transmitter battery (Click here).
From outside the vehicle, approximately 1 m (3.28 ft) from the driver door outside door handle, test the door control transmitter module set sub-assembly by pointing its key plate at the vehicle and pressing a door control transmitter module set sub-assembly switch.
Inspect the battery capacity. (Type A)
Remove the transmitter battery from the door control transmitter module set sub-assembly that does not operate. Attach a lead wire (0.6 mm (0.0236 in.) in diameter or less including wire sheath) with tape or equivalent to the negative terminal (Click here).
![]() |
Carefully pull the lead wire out from the position shown in the illustration and install the previously removed transmitter battery.
![]() |
Check the transmitter battery voltage.
| Tester Connection | Condition | Specified Condition |
| Battery positive (+) - Battery negative (-) | Ignition switch off, all doors closed and lock or unlock switch is pressed | 2.5 to 3.2 V |
Inspect operation of the door control transmitter module set sub-assembly. (Type B)
Remove the transmitter battery from the door control transmitter module set sub-assembly (Click here).
![]() |
Install a new or non-depleted transmitter battery (Click here).
From outside the vehicle, approximately 1 m (3.28 ft) from the driver door outside door handle, test the door control transmitter module set sub-assembly by pointing its key plate at the vehicle and pressing a door control transmitter module set sub-assembly switch.
Inspect the battery capacity. (Type B)
Remove the transmitter battery from the door control transmitter module set sub-assembly that does not operate. Attach a lead wire (0.6 mm (0.0236 in.) in diameter or less including wire sheath) with tape or equivalent to the negative terminal (Click here).
![]() |
Carefully pull the lead wire out from the position shown in the illustration and install the previously removed transmitter battery.
![]() |
Check the transmitter battery voltage.
| Tester Connection | Condition | Specified Condition |
| Battery positive (+) - Battery negative (-) | Ignition switch off, all doors closed and lock or unlock switch is pressed | 2.5 to 3.2 V |