DTC B1247 Tire Pressure Monitor Receiver Communication Stop |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1247 | In diagnostic mode, an applicable RDA signal cannot be received within 10 seconds after a PRG signal is sent from the main body ECU (multiplex network body ECU). |
|

| 1.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) - TIRE PRESSURE WARNING ECU AND RECEIVER) |
Disconnect the N47 tire pressure warning ECU and receiver connector.
Disconnect the I13 main body ECU (multiplex network body ECU) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| N47-4 (RDA2) - I13-16 (RDA) | Always | Below 1 Ω |
| N47-4 (RDA2) or I13-16 (RDA) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (POWER SOURCE OF TIRE PRESSURE WARNING ECU AND RECEIVER) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| N47-12 (GND) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| N47-1 (IG) - Body ground | Engine switch on (IG) | 10 to 16 V |
| *a | Front view of wire harness connector (to Tire Pressure Warning ECU and Receiver) |
|
| ||||
| OK | |
| 3.REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER |
Replace the tire pressure warning ECU and receiver (Click here).
| NEXT | |
| 4.CHECK DTC OUTPUT (B1247) |
Clear the DTCs (Click here).
Turn the engine switch off.
Turn the engine switch on (IG).
Check for DTCs (Click here).
|
| ||||
| OK | ||
| ||