Home › Vehicle Exterior › WIPER / WASHER › HEADLIGHT CLEANER ACTUATOR

HEADLIGHT CLEANER ACTUATOR > REMOVAL

for Preparation Click here


  1. Use the same procedure for the RH side and LH side.
  2. The following procedure is for the LH side.


1. REMOVE FRONT BUMPER ASSEMBLY
(Click here)


2. REMOVE HEADLIGHT WASHER NOZZLE SUB-ASSEMBLY


    E301634
  1. Extend the headlight washer actuator sub-assembly.

  1. Disengage the claw to remove the headlight washer nozzle sub-assembly.



3. REMOVE HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY


    E301626
  1. Disconnect the headlight cleaner hose.



    E301627
  1. Remove the headlight cleaner clamp as shown in the illustration.



    E301629
  1. Pull the headlight cleaner actuator clamp as shown in the illustration.



  1. While pushing the tab indicated by the arrow (A), disengage the claw and guide to remove the headlight washer actuator sub-assembly as shown in the illustration.


    E301631E01