FRONT DOOR BELT MOULDING (for TMMK Made) > INSTALLATION |
| 1. PRECAUTION |
| 2. INSTALL FRONT DOOR BELT MOULDING ASSEMBLY |
![]() |
Engage the 5 claws to install the front door belt moulding assembly.
| 3. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY |
Connect the cable to the negative (-) battery terminal.
for Driver Side:
Connect the power window regulator master switch assembly and move the front door glass sub-assembly so that the door glass bolts can be seen.
Disconnect the power window regulator master switch assembly.
for Front Passenger Side:
Connect the power window regulator switch assembly and move the front door glass sub-assembly so that the door glass bolts can be seen.
Disconnect the power window regulator switch assembly.
Disconnect the cable from the negative (-) battery terminal.
![]() |
Insert the front door glass sub-assembly into the front door panel along the front door glass run as indicated by the arrows, in the order shown in the illustration.
![]() |
Install the front door glass sub-assembly with the 2 bolts.
![]() |
Install the grommet.
| 4. INSTALL NO. 2 FRONT DOOR SERVICE HOLE SEAL |
![]() |
Install the No. 2 front door service hole seal.
| 5. INSTALL NO. 1 FRONT DOOR SERVICE HOLE SEAL |
![]() |
Install the No. 1 front door service hole seal.
| 6. INSTALL FRONT DOOR SERVICE HOLE COVER |
Apply new butyl tape to the front door panel.
![]() |
Pass the front door lock remote control cable assembly, front door inside locking cable assembly and each connector through a new front door service hole cover.
| *a | Reference Point |
Install the front door service hole cover according to the reference points on the front door panel.
Engage the 5 clamps.
Install the bolt.
Connect each connector.
| 7. INSTALL DOOR SIDE AIRBAG SENSOR |
Check that the engine switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Before connecting the connector, check that the position of the white housing lock is correct as shown in the illustration.

| *a | Incorrect | *b | Correct |
Insert the pin (stopper) into the door hole and install the door side airbag sensor to the front door panel with the bolt.
Connect the connector to the door side airbag sensor.
Be sure to engage the connectors until they are locked (when locking, make sure that a click sound can be heard).

| *1 | White Housing Lock | *2 | Yellow CPA |
| *a | Connection is Completed | - | - |
Check that there is no looseness in the installation parts of the door side airbag sensor.
| 8. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY |
| 9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 10. INITIALIZE POWER WINDOW CONTROL SYSTEM (for Driver Side) |
| 11. INSPECT POWER WINDOW OPERATION |
| 12. INSPECT SRS WARNING LIGHT |