FRONT DOOR WINDOW FRAME MOULDING (for TMC, TMMR Made) > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY |
| 4. REMOVE FRONT DOOR SERVICE HOLE COVER |
![]() |
Disconnect each connector.
Disengage the 4 clamps.
Remove the front door service hole cover.
| 5. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY |
![]() |
Remove the grommet.
Connect the cable to the negative (-) battery terminal.
Connect the multiplex network master switch assembly and move the front door glass sub-assembly so that the door glass bolts can be seen.
Disconnect the cable from the negative (-) battery terminal.
Disconnect the multiplex network master switch assembly.
![]() |
Remove the 2 bolts.
![]() |
Remove the front door glass sub-assembly as indicated by the arrows, in the order shown in the illustration.
| 6. REMOVE FRONT DOOR GLASS RUN |
![]() |
Remove the front door glass run.
| 7. REMOVE FRONT DOOR BELT MOULDING ASSEMBLY |
![]() |
Put protective tape around the front door belt moulding assembly.
| *1 | Protective Tape |
![]() |
Using a screwdriver with the tip wrapped with protective tape, disengage the 6 claws and remove the front door belt moulding assembly.
| *1 | Protective Tape |
| 8. REMOVE FRONT DOOR CHECK ASSEMBLY |
![]() |
Remove the 3 bolts and front door check assembly.
| 9. REMOVE FRONT DOOR WEATHERSTRIP |
![]() |
Using a clip remover, disengage the 19 clips and remove the front door weatherstrip.
| 10. REMOVE FRONT DOOR REAR WINDOW FRAME MOULDING |
| Item | Temperature |
| Vehicle Body | 40 to 60°C (104 to 140°F) |
| Moulding | 20 to 30°C (68 to 86°F) |
Using a heat light, heat the front door rear window frame moulding.
![]() |
Using a moulding remover, disengage the clip and remove the front door rear window frame moulding.
| *1 | Double-sided Tape |
| *2 | Caulking Sponge |
| 11. REMOVE FRONT DOOR UPPER WINDOW FRAME MOULDING |
Insert a 4.0 mm (0.157 in.) drill bit into a drill.
![]() |
Tape a 4.0 mm (0.157 in.) drill bit 5.0 mm (0.197 in.) from the tip as shown in the illustration.
| Area | Dimension |
| A | 5.0 mm |
Lightly press the drill against the rivets to drill off the rivet flanges, and remove the 7 rivets.
Using a vacuum cleaner, remove the rivet fragments and shavings from the drilled areas.
Disengage the claw and guide, and remove the front door upper window frame moulding from the door frame.