FRONT DOOR BELT MOULDING (for TMMK Made) > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY |
| 4. REMOVE DOOR SIDE AIRBAG SENSOR |
Check that the engine switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Disconnect the connector from the door side airbag sensor.
Push down the white housing lock and slide the yellow CPA. (At this time, the connector cannot be disconnected yet.)

| *1 | White Housing Lock | *2 | Yellow CPA |
| *a | Connector Lock is Released | - | - |
Push down the white housing lock again and disconnect the connector.
![]() |
Remove the bolt and door side airbag sensor from the front door panel.
After disconnecting the connector, check that the position of the white housing lock is correct as shown in the illustration.

| *a | Incorrect | *b | Correct |
| 5. REMOVE FRONT DOOR SERVICE HOLE COVER |
![]() |
Remove the bolt.
Disconnect each connector.
Disengage the 5 clamps.
Pass the front door lock remote control cable assembly, front door inside locking cable assembly and each connector through the front door service hole cover.
Remove the front door service hole cover.
| 6. REMOVE NO. 1 FRONT DOOR SERVICE HOLE SEAL |
![]() |
Remove the No. 1 front door service hole seal.
| 7. REMOVE NO. 2 FRONT DOOR SERVICE HOLE SEAL |
![]() |
Remove the No. 2 front door service hole seal.
| 8. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY |
![]() |
Remove the grommet.
Connect the cable to the negative (-) battery terminal.
for Driver Side:
Connect the power window regulator master switch assembly and move the front door glass sub-assembly so that the door glass bolts can be seen.
Disconnect the power window regulator master switch assembly.
for Front Passenger Side:
Connect the power window regulator switch assembly and move the front door glass sub-assembly so that the door glass bolts can be seen.
Disconnect the power window regulator switch assembly.
Disconnect the cable from the negative (-) battery terminal.
![]() |
Remove the 2 bolts.
![]() |
Remove the front door glass sub-assembly as indicated by the arrows, in the order shown in the illustration.
| 9. REMOVE FRONT DOOR BELT MOULDING ASSEMBLY |
![]() |
Apply protective tape around the front door belt moulding assembly as shown in the illustration.
![]() | Protective Tape |
![]() |
Using a screwdriver with its tip wrapped with protective tape, disengage the 5 claws as shown in the illustration and remove the front door belt moulding assembly.
| *a | Screwdriver |
![]() | Protective Tape |