Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SENSOR

BLIND SPOT MONITOR SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL BLIND SPOT MONITOR COVER LH
  1. Engage the claw.

  1. Install the blind spot monitor cover LH with the 2 nuts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }



2. INSTALL BLIND SPOT MONITOR COVER RH

HINT:
Use the same procedure as for the LH side.



3. INSTALL BLIND SPOT MONITOR SENSOR LH

NOTICE:
Replace the blind spot monitor sensor LH if it has been dropped or subjected to a severe impact.

  1. Connect the connector.

  1. Install the blind spot monitor sensor LH with the 3 nuts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. Engage the 2 clamps.



4. INSTALL BLIND SPOT MONITOR SENSOR RH

NOTICE:
Replace the blind spot monitor sensor RH if it has been dropped or subjected to a severe impact.

  1. Connect the connector.

  1. Install the blind spot monitor sensor RH with the 3 nuts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. Engage the clamp.



5. INSTALL REAR BUMPER ASSEMBLY
(Click here)


6. PERFORM BLIND SPOT MONITOR BEAM AXIS INSPECTION
(Click here)


7. PERFORM BLIND SPOT MONITOR BEAM AXIS CONFIRMATION
(Click here)
SST
09870-60000   (09870-60010)
09870-60040  


8. PERFORM DIAGNOSTIC SYSTEM CHECK
(Click here)