Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › ULTRASONIC SENSOR (for Front Side)

ULTRASONIC SENSOR (for Front Side) > REMOVAL

for Preparation Click here



1. REMOVE FRONT BUMPER ASSEMBLY
(Click here)


2. REMOVE NO. 1 ULTRASONIC SENSOR

HINT:
Use the same procedure for all No. 1 ultrasonic sensors.



    E305606
  1. Disconnect the connector.

    HINT:
    This illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.



    E305607
  1. Disengage the 2 claws to remove the No. 1 ultrasonic sensor.

    HINT:
    This illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.



3. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER

HINT:
Use the same procedure for all No. 1 ultrasonic sensor retainers.



    E305608
  1. Disengage the 2 claws to remove the No. 1 ultrasonic sensor retainer from the front bumper assembly.

    HINT:
    This illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.