Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING PANEL (for TMMK Made)

AIR CONDITIONING PANEL (for TMMK Made) > INSTALLATION

for Preparation Click here



1. INSTALL AIR CONDITIONING CONTROL ASSEMBLY
  1. Engage the 2 clips to install the air conditioning control assembly.



2. INSTALL NO. 1 RADIO RECEIVER BRACKET
  1. Install the No. 1 radio receiver bracket with the 5 screws.



3. INSTALL NO. 2 RADIO RECEIVER BRACKET
  1. Install the No. 2 radio receiver bracket with the 5 screws.



4. INSTALL RADIO RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY (w/o Navigation System)
  1. Connect each connector.

  1. Engage the 4 clips to the vehicle body to temporarily install the radio receiver assembly with air conditioning control assembly.

  1. Install the radio receiver assembly with air conditioning control assembly with the 4 bolts and 2 screws.



5. INSTALL NAVIGATION RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY (w/ Navigation System)
  1. Connect each connector.

  1. Engage the 4 clips to the vehicle body to temporarily install the navigation receiver assembly with air conditioning control assembly.

  1. Install the navigation receiver assembly with air conditioning control assembly with the 4 bolts and 2 screws.



6. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY
  1. Connect each connector.



    B377623
  1. Engage the guide and 2 clips as shown in the illustration.

  1. Install the upper console panel sub-assembly with the 2 screws <C> or <D>.



7. INSTALL NO. 1 SPEAKER OPENING COVER ASSEMBLY
  1. Connect the connector.

  1. Engage the clamp.



    B377625
  1. Engage the 11 clips to install the No. 1 speaker opening cover assembly as shown in the illustration.



8. INSTALL REAR CONSOLE UPPER PANEL SUB-ASSEMBLY
  1. Engage the 6 clips.

  1. Install the rear console upper panel sub-assembly with the 2 screws <C> or <D>.

  1. Connect the connector.

  1. Move the shift lever to P.



9. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY


    B377617
  1. Turn the shift lever knob sub-assembly clockwise to install the shift lever knob sub-assembly.



    B373546
  1. Engage the 2 claws as shown in the illustration.



10. INSTALL UPPER CONSOLE BOX SUB-ASSEMBLY
  1. w/ Seat Heater System:

    1. Connect each connector.

  1. Engage the 4 clips to install the upper console box sub-assembly.



11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Navigation System)

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).