Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING PANEL (for TMMK Made)

AIR CONDITIONING PANEL (for TMMK Made) > REMOVAL

for Preparation Click here



1. PRECAUTION (w/ Navigation System)

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Navigation System)

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE UPPER CONSOLE BOX SUB-ASSEMBLY


    B377618
  1. Disengage the 4 clips and remove the upper console box sub-assembly.

  1. w/ Seat Heater System:

    1. Disconnect each connector.



4. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY


    B377615
  1. Disengage the 2 claws as shown in the illustration.



    B377616
  1. Turn the shift lever knob sub-assembly counterclockwise and remove the shift lever knob sub-assembly.



5. REMOVE REAR CONSOLE UPPER PANEL SUB-ASSEMBLY
  1. Move the shift lever to N.



    B403737
  1. Disconnect the connector.

  1. Remove the 2 screws <C> or <D>.



    B377620
  1. Disengage the 6 clips and remove the rear console upper panel sub-assembly.



6. REMOVE NO. 1 SPEAKER OPENING COVER ASSEMBLY


    B377624
  1. Using a moulding remover, disengage the 11 clips as shown in the illustration.

  1. Disconnect the connector to remove the No. 1 speaker opening cover assembly.



7. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY


    B403738
  1. Remove the 2 screws <C> or <D>.



    B377622
  1. Disengage the 2 clips and guide as shown in the illustration.

  1. Disconnect each connector to remove the upper console panel sub-assembly.



8. REMOVE RADIO RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY (w/o Navigation System)


    E300869E01
  1. Apply protective tape to the areas shown in the illustration.
    Text in Illustration 
    *a
    Protective Tape



    E300871
  1. Remove the 4 bolts and 2 screws.



    E300873
  1. Pull the radio receiver assembly with air conditioning control assembly toward the rear of the vehicle to disengage the 4 clips.

  1. Disconnect each connector and remove the radio receiver assembly with air conditioning control assembly.



9. REMOVE NAVIGATION RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY (w/ Navigation System)


    E300870E01
  1. Apply protective tape to the areas shown in the illustration.
    Text in Illustration 
    *a
    Protective Tape



    E300872
  1. Remove the 4 bolts and 2 screws.



    E300874
  1. Pull the navigation receiver assembly with air conditioning control assembly toward the rear of the vehicle to disengage the 4 clips.

  1. Disconnect each connector and remove the navigation receiver assembly with air conditioning control assembly.



10. REMOVE NO. 1 RADIO RECEIVER BRACKET


    E300876
  1. Remove the 5 screws and No. 1 radio receiver bracket.



11. REMOVE NO. 2 RADIO RECEIVER BRACKET


    E300878
  1. Remove the 5 screws and No. 2 radio receiver bracket.



12. REMOVE AIR CONDITIONING CONTROL ASSEMBLY


    E300726
  1. Disengage the 2 clips to remove the air conditioning control assembly.