AMPLIFIER ANTENNA (for TMC, TMMR Made) > INSTALLATION |
| 1. INSTALL AMPLIFIER ANTENNA ASSEMBLY |
Install the amplifier antenna assembly with the 2 bolts.
Connect the 4 connectors and engage the clamp.
| 2. INSTALL ROOF SIDE INNER GARNISH RH |
| 3. INSTALL REAR SEAT SIDE GARNISH RH (for Reclining Seat Type) |
| 4. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH |
![]() |
Align the alignment mark (Blue) on the weatherstrip with the protruding portion on the body indicated by the arrow in the illustration, and install the rear door opening trim weatherstrip RH.
| *1 | Alignment Mark (Blue) |
| 5. INSTALL REAR DOOR SCUFF PLATE RH (for Reclining Seat Type) |
| 6. INSTALL REAR SEATBACK ASSEMBLY RH (for Reclining Seat Type) |
Place the rear seatback assembly RH in the cabin.
Install the rear seatback assembly RH with the 2 bolts and 2 nuts.
Engage the 2 hooks to install the cover.
Connect the rear seat belt to the rear seat shoulder belt guide.
w/ Rear Seat Side Airbag:
Connect each connector and clamp to the child restraint anchor bracket sub-assembly RH.
| 7. INSTALL REAR SEATBACK COVER (for Reclining Seat Type) |
Engage the 4 claws to install the 2 rear seatback covers.
| 8. INSTALL REAR SEAT HEADREST ASSEMBLY (for Reclining Seat Type) |
| 9. INSTALL REAR SEAT CUSHION LOCK HOOK (for Reclining Seat Type) |
![]() |
Engage the 2 claws to install a new rear seat cushion lock hook as shown in the illustration.
| 10. INSTALL REAR SEAT CUSHION ASSEMBLY (for Reclining Seat Type) |
Place the rear seat cushion assembly in the cabin.
Pass the 2 rear seat inner belt assemblies through the rear seat cushion assembly.
Connect the 2 seat heater connectors.
![]() |
Engage the 2 rear seat cushion frame hooks on the front side of the rear seat cushion assembly to the 2 rear seat cushion lock hooks as shown in the illustration.
Confirm that the rear seat cushion assembly is securely installed.
| 11. INSTALL REAR SIDE SEATBACK ASSEMBLY RH (for Fold Down Seat Type) |
Place the rear side seatback assembly RH in the cabin.
Engage the hook to install the rear side seatback assembly RH with the bolt.
Connect the rear seat outer belt assembly to the rear seat shoulder belt guide RH.
| 12. INSTALL REAR SEAT CUSHION LOCK HOOK (for Fold Down Seat Type) |
![]() |
Engage the 2 claws to install a new rear seat cushion lock hook as shown in the illustration.
| 13. INSTALL REAR SEAT CUSHION ASSEMBLY (for Fold Down Seat Type) |
Place the rear seat cushion assembly in the cabin.
w/ Seat Heater System:
Engage the 2 clamps.
Connect the connector.
![]() |
Engage the 2 hooks of the rear seat cushion assembly to the vehicle body as shown in the illustration.
Confirm that the rear seat cushion assembly is firmly installed.
| 14. INSTALL REAR SEATBACK ASSEMBLY RH (for Fold Down Seat Type) |
| 15. INSTALL REAR SEATBACK ASSEMBLY LH (for Fold Down Seat Type) |
| 16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Rear Seat Side Airbag) |
| 17. INSPECT SRS WARNING LIGHT (w/ Rear Seat Side Airbag) |