DTC C1381 Acceleration Sensor Power Supply Voltage Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1381 | Vehicle speed is 6 km/h (4 mph) and yaw rate and acceleration sensor power supply malfunction signal is received for 1.1 seconds or more. |
|
| 1.CHECK HARNESS AND CONNECTOR (POWER SOURCE TERMINAL) |
![]() |
Make sure that there is no looseness at the locking part and the connecting part of the connector.
Disconnect the yaw rate and acceleration sensor (airbag sensor assembly) connector.
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I47-21 (IG2) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector (to Yaw Rate and Acceleration Sensor (Airbag Sensor Assembly)) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (GROUND TERMINAL) |
![]() |
Turn the ignition switch off.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I47-25 (E1) - Body ground | Always | Below 1 Ω |
| I47-26 (E2) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to Yaw Rate and Acceleration Sensor (Airbag Sensor Assembly)) |
| Result | Proceed to |
| OK (for TMC, TMMR Made) | A |
| OK (for TMMK Made) | B |
| NG | C |
|
| ||||
|
| ||||
| A | ||
| ||