EMISSION CONTROL SYSTEM > ON-VEHICLE INSPECTION |
| 1. INSPECT FUEL CUT OPERATION |
Increase the engine speed to approximately 3500 rpm.
![]() |
Use a sound scope to check for injector operating sounds.
| *1 | Fuel Injector Assembly |
| *a | Sound Scope |
When the accelerator pedal is fully released, check that injector operating sounds stop momentarily and then resume.
| Item | Specified Condition |
| Fuel injection restart engine speed | 1400 rpm |
| 2. VISUALLY CHECK HOSES, CONNECTIONS AND GASKETS |
Visually check that the hoses, connections and gaskets have no cracks, leaks or damage.
| 3. INSPECT EVAPORATIVE EMISSION CONTROL SYSTEM |
Connect the GTS to the DLC3.
![]() |
Slide the clip and disconnect the fuel vapor feed hose assembly from the purge valve (purge VSV).
Start the engine.
Turn the GTS on.
Enter the following menus: Powertrain / Engine / Active Test / Activate the EVAP Purge VSV.
Check that vacuum occurs at the purge valve (purge VSV) port.
If vacuum does not occur, check the following items:
Exit Active Test mode, connect the fuel vapor feed hose assembly to the purge valve (purge VSV) and slide the clip to secure it.
Enter the following menus: Powertrain / Engine / Data List / EVAP (Purge) VSV.
Warm up the engine and drive the vehicle.
Confirm that the purge valve (purge VSV) opens.
If the result is not as specified, replace the purge valve (purge VSV), wire harness or ECM.