Home › Drivetrain · U660E AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSAXLE SYSTEM

DTC    U0100    Lost Communication with ECM / PCM "A"

for Preparation Click here


DESCRIPTION

The engine control unit communicates with the TCM using the Controller Area Network (CAN).
If there is a problem in this communication, the TCM sets a DTC.

DTC No.
DTC Detection Condition
Trouble Area
U0100
Following conditions are met for 1.25 seconds (1 trip detection logic):
  1. Engine switch on (IG)
  2. Battery voltage is 10.5 V or more
  3. No communication between the engine control ECU (ECM) and TCM
  1. Harness and connector
  2. ECM
  3. TCM

WIRING DIAGRAM


C346760E01


INSPECTION PROCEDURE

HINT:
  1. Refer to inspection procedure for CAN communication system.
  2. If the CAN communication malfunctions, the TCM cannot receive the current data from the ECM. In this case, the freeze frame data output from the TCM has not been updated, so the data will not be useful for the inspection. However, reading the Data List as the first step in troubleshooting is effective to find malfunctions.
  3. The malfunction area can be checked using the Bus Check function on the intelligent tester (Click here).

1.CHECK ECU TERMINAL VOLTAGE (+B AND E1 TERMINALS)


    C189544E67
  1. Disconnect the TCM connector.

  1. Turn the engine switch on (IG).

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    E7-18 (+B) - E7-8 (E1)
    Engine switch on (IG)
    9 to 14 V

  1. Turn the engine switch off.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E7-8 (E1) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to TCM)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (TCM - ECM)
  1. Disconnect the TCM connector.

  1. Disconnect the ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E7-6 (CAN+) - E26-31 (CAN+)
    Always
    Below 1 Ω
    E7-7 (CAN-) - E26-1 (CAN-)
    Always
    Below 1 Ω
    E7-6 (CAN+) or E26-31 (CAN+) - Body ground and other terminals
    Always
    10 kΩ or higher
    E7-7 (CAN-) or E26-1 (CAN-) - Body ground and other terminals
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK IF DTC OUTPUT RECURS
  1. Connect the intelligent tester to the DLC3.

  1. Clear the DTCs.

  1. Replace the TCM.

    HINT:
    Replace the TCM with a TCM from a normally functioning vehicle of the same model.

  1. Start the engine.

  1. Read the DTCs.

    Result:

    Display (DTC Output)
    Proceed to
    U0100
    A
    No DTC
    B



B
REPLACE TCM (Click here)
A

REPLACE ECM (Click here)