Home › Drivetrain ยท U761E AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSAXLE SYSTEM

DTC    U010087    Lost Communication with ECM/PCM "A" Missing Message

for Preparation Click here


DESCRIPTION

The engine control unit and transmission control unit are located inside the ECM. The engine control unit intercommunicates with the transmission control ECU using CAN communication.
If there is a problem in this intercommunication, the ECM stores this DTC.

DTC No.
DTC Detection Condition
Trouble Area
U010087
1. Diagnosis Condition 2. Malfunction Status 3. Malfunction Time 4. Other
  1. The engine switch is on (IG) and battery voltage is 9.5 V or more.
  2. No intercommunication between engine control ECU and transmission control ECU
  3. 1.25 seconds or more
  4. 1-trip detection logic
ECM

INSPECTION PROCEDURE

NOTICE:
Perform registration and/or initialization when parts related to the automatic transaxle are replaced (Click here).

HINT:
After performing repair, clear the DTCs and perform the following procedure to check that DTCs are not output.
  1. Check the battery voltage is 9.5 V or more.
  2. Turn the engine switch on (IG).
  3. Check for DTCs again (Click here).

1.CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC U010087)
  1. Connect the GTS to the DLC3.

  1. Turn the engine switch on (IG).

  1. Enter the following menus: Powertrain / Transmission / Trouble Codes.

  1. Check if DTCs are output.

    Result:
    Result
    Proceed to
    Only DTC U010087 is output
    A
    DTC U010087 and other DTCs are output
    B



B
GO TO DTC CHART (Click here)
A

REPLACE ECM (Click here)