Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > Meter Illumination is Always Dark

for Preparation Click here


DESCRIPTION

The combination meter assembly receives signals from this circuit to adjust the illumination of the combination meter assembly. The combination meter assembly sets the illumination level based on the user operation of the light control rheostat switch.

WIRING DIAGRAM


E143765E73


INSPECTION PROCEDURE

HINT:
  1. The meter illumination level can be adjusted by operating the light control rheostat.
  2. The meter illumination dims when the headlight dimmer switch assembly is turned to the tail, head or AUTO position at night.
  3. Before starting the following inspection, check if lighting system DTCs are output (Click here).

1.CHECK CAN COMMUNICATION SYSTEM
  1. Check if a CAN communication DTC is output (Click here).

    Result:
    Result
    Proceed to
    CAN communication DTC is not output.
    A
    CAN communication DTC is output.
    B



B
GO TO CAN COMMUNICATION SYSTEM (Click here)
A


2.READ VALUE USING GTS (ILLUMINATION RATE INFO)
  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch ON.

  1. Turn the GTS on.

  1. Enter the following menus: Body Electrical / Main Body / Data List.

  1. Read the Data List according to the display on the GTS.

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Illumination Rate Info
    Illumination rate information/0 ms to 2162.65 ms
    Value is output according to ambient light levels
    -

    Result:

    Result
    Proceed to
    The output value changes according to the ambient light level.
    A
    The output value does not change according to the ambient light level.
    B



B
CHECK LIGHTING SETTING (Click here)
A


3.REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)
  1. Replace the main body ECU (multiplex network body ECU) with a new or known good one (Click here).

    OK:
    The operation of the combination meter assembly returns to normal.

    HINT:
    The combination meter assembly controls the meter illumination based on an auto dimmer signal from the main body ECU (multiplex network body ECU). When the meter illumination is always dark (very dim), it may be due to the main body ECU (multiplex network body ECU) sending an auto dimmer signal to the meter ECU because of a malfunction in the main body ECU (multiplex network body ECU).



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK

END