Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY (for TMMK Made Manual Seat)

FRONT SEAT ASSEMBLY (for TMMK Made Manual Seat) > REMOVAL

for Preparation Click here


CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.



1. PRECAUTION

CAUTION:
  1. Be sure to read Precaution thoroughly before servicing (Click here).
  2. If the side airbag was deployed, replace the front seat airbag assembly, front seatback frame sub-assembly, separate type front seatback pad and separate type front seatback cover with the necessary parts in accordance with the extent of the collision damage.

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE FRONT SEAT HEADREST ASSEMBLY


4. REMOVE REAR OUTER SEAT TRACK BRACKET COVER
  1. Lift up the seat track adjusting handle and move the front seat assembly to the foremost position.



    B381965
  1. Disengage the 2 claws and remove the rear outer seat track bracket cover.



5. REMOVE REAR INNER SEAT TRACK BRACKET COVER


    B381966
  1. Disengage the 2 claws and remove the rear inner seat track bracket cover.



6. REMOVE FRONT SEAT ASSEMBLY


    B381188
  1. Remove the 2 bolts on the rear side of the front seat assembly.

  1. Lift up the seat track adjusting handle and move the front seat assembly to the rearmost position.

  1. Remove the 2 bolts on the front side of the front seat assembly.

  1. Disconnect each connector and clamp under the front seat assembly.

  1. Lift up the seat track adjusting handle and move the front seat assembly to the center position. Then, operate the reclining adjuster release handle and move the seatback to the upright position.

  1. Remove the front seat assembly.

    NOTICE:
    Be careful not to damage the vehicle body.