Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM (for Radio and Display Type)

AUDIO AND VISUAL SYSTEM (for Radio and Display Type) > Reverse Signal Circuit

for Preparation Click here


DESCRIPTION

The radio and display receiver assembly receives a reverse signal from the park/neutral position switch assembly.

WIRING DIAGRAM


E226161E45


INSPECTION PROCEDURE

1.CHECK BACK-UP LIGHT
  1. Move the shift lever to R and check if the back-up lights come on.

    OK:
    The back-up lights come on.



NG
GO TO LIGHTING SYSTEM (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (REVERSE SIGNAL)
  1. Disconnect the I155 radio and display receiver assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    I155-2 (REV) - Body ground
    Ignition switch ON
    Shift lever in R
    11 to 14 V
    I155-2 (REV) - Body ground
    Ignition switch ON
    Shift lever in any position other than R
    Below 1 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)