NAVIGATION SYSTEM (for Radio and Display Type) > Reverse Signal Circuit |

| 1.CHECK HARNESS AND CONNECTOR (REVERSE SIGNAL) |
Disconnect the I155 radio and display receiver assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I155-2 (REV) - Body ground | Ignition switch ON Shift lever in R | 11 to 14 V |
| I155-2 (REV) - Body ground | Ignition switch ON Shift lever other than R | Below 1 V |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - PARK/NEUTRAL POSITION SWITCH ASSEMBLY) |
Disconnect the I155 radio and display receiver assembly connector.
Disconnect the E85 park/neutral position switch assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I155-2 (REV) - E85-2 (RL) | Always | Below 1 Ω |
| I155-2 (REV) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (PARK/NEUTRAL POSITION SWITCH ASSEMBLY - BATTERY) |
Disconnect the E85 park/neutral position switch assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E85-1 (RB) - Body ground | Ignition switch ON | 11 to 14 V |
| Result | Proceed to |
| NG | A |
| OK | B |
|
| ||||
| A | ||
| ||