NAVIGATION SYSTEM (for Radio and Display Type) > Data Signal Circuit between Stereo Jack Adapter and Extension Module |

| 1.CHECK HARNESS AND CONNECTOR (NAVIGATION ECU - NO. 1 STEREO JACK ADAPTER ASSEMBLY) |
![]() |
Disconnect the u4 navigation ECU connector.
Disconnect the I207 No. 1 stereo jack adapter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| u4-2 (USI-) - I207-2 (UDO-) | Always | Below 1 Ω |
| u4-3 (USI+) - I207-3 (UDO+) | Always | Below 1 Ω |
| u4-5 (USG1) - I207-5 (USG1) | Always | Below 1 Ω |
| u4-2 (USI-) - Body ground | Always | 10 kΩ or higher |
| u4-3 (USI+) - Body ground | Always | 10 kΩ or higher |
| u4-5 (USG1) - Body ground | Always | 10 kΩ or higher |
| *a | Front view of wire harness connector (to Navigation ECU) |
| *b | Front view of wire harness connector (to No. 1 Stereo Jack Adapter Assembly) |
|
| ||||
| OK | ||
| ||