Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for Navigation Receiver Type)

NAVIGATION SYSTEM (for Navigation Receiver Type) > Mute Signal Circuit between Navigation Receiver Assembly and Stereo Component Amplifier

for Preparation Click here


DESCRIPTION

This circuit sends a signal to the stereo component amplifier assembly to mute noise. Due to this, the noise produced by changing the sound source ceases.
If there is an open in the circuit, noise can be heard from the speakers when changing the sound source.
If there is a short in the circuit, even though the stereo component amplifier assembly is functioning normally, no sound or only an extremely faint sound can be heard.

WIRING DIAGRAM


E262317E83


INSPECTION PROCEDURE

1.INSPECT STEREO COMPONENT AMPLIFIER ASSEMBLY


    E225824E59
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    I69-1 (MUTE) - Body ground
    Ignition switch ACC
    Audio system playing
    → Audio system changing modes
    2.0 V or higher
    → Below 1 V

    Text in Illustration 
    *a
    Component with harness connected
    (Stereo Component Amplifier Assembly)



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY)
  1. Disconnect the I67 navigation receiver assembly connector.

  1. Disconnect the I69 stereo component amplifier assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I67-16 (MUT1) - I69-1 (MUTE)
    Always
    Below 1 Ω
    I67-16 (MUT1) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT STEREO COMPONENT AMPLIFIER ASSEMBLY
  1. Disconnect the I67 navigation receiver assembly connector.



    E221772E48
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    I67-16 (MUT1) - Body ground
    Ignition switch ACC
    Audio system playing
    2.0 V or higher

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Navigation Receiver Assembly)

    Result:
    Result
    Proceed to
    NG
    A
    OK (for TMMK Made)
    B
    OK (for TMC Made)
    C



B
REPLACE NAVIGATION RECEIVER ASSEMBLY (for TMMK Made) (Click here)

C
REPLACE NAVIGATION RECEIVER ASSEMBLY (for TMC Made) (Click here)
A

REPLACE STEREO COMPONENT AMPLIFIER ASSEMBLY (Click here)