PUSH-BUTTON START > Power Source Mode does not Change to ON (ACC) |

| Problem Symptom | Data List Item | Active Test Item |
| Power source mode does not change to on (ACC) but does change to on (IG) | Power Source Control
| - |
| 1.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) - INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY) |
Disconnect the I78 connector from the certification ECU (smart key ECU assembly).
Disconnect the 3B connector from the instrument panel junction block assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I78-4 (ACCD) - 3B-23 | Always | Below 1 Ω |
| 3B-7 - Body ground | Always | Below 1 Ω |
| I78-4 (ACCD) or 3B-23 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY |
Remove the instrument panel junction block assembly (Click here).

| *a | Component without harness connected (Instrument Panel Junction Block Assembly) | - | - |
Remove the main body ECU (multiplex network body ECU) from the instrument panel junction block assembly (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Battery voltage not applied to terminals 3B-23 and 3B-7 | 10 kΩ or higher |
| Battery voltage applied to terminals 3B-23 and 3B-7 | Below 1 Ω |
|
| ||||
| OK | |
| 3.INSPECT CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) |
![]() |
Reconnect the I78 certification ECU (smart key ECU assembly) connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I78-4 (ACCD) - Body ground | Engine switch off → Engine switch on (ACC) | 1 V or less → 8.5 V or higher |
| *a | Component with harness connected (Certification ECU (Smart Key ECU Assembly)) |
|
| ||||
| OK | ||
| ||