PARKING BRAKE PEDAL (for LHD) > INSTALLATION |
| 1. INSTALL PARKING BRAKE CONTROL PEDAL ASSEMBLY |
![]() |
Install the parking brake control pedal assembly with the bolt and 2 nuts.
Connect the parking brake switch connector.
![]() |
Install the No. 1 parking brake cable assembly with the bolt and 2 nuts.
Install the clip to the No. 1 parking brake cable assembly.
Install the floor carpet.
for TMC, TMMR Made:
![]() |
Temporarily install the lock nut.
| *1 | Lock Nut |
| *2 | Adjusting Nut |
| 2. CONNECT NO. 4 PARKING BRAKE CABLE ASSEMBLY |
![]() |
for TMC, TMMR Made:
| *a | Turn |
| *b | Hold |
Connect the No. 4 parking brake cable assembly to the parking brake control pedal assembly as shown in the illustration.
![]() |
for TMMK Made:
| *a | Turn |
| *b | Hold |
Connect the No. 4 parking brake cable assembly to the parking brake control pedal assembly as shown in the illustration.
| 3. INSTALL AIRBAG SENSOR ASSEMBLY |
| 4. INSTALL FLOOR CARPET BRACKET RH |
| 5. INSTALL NO. 1 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY (w/ Smart Entry and Start System) |
Connect the connector.
Install the No. 1 indoor electrical key antenna assembly with the bolt.
Engage the clamp.
| 6. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Driver Side Knee Airbag) |
| 7. INSTALL SHIFT LEVER SUPPORT |
| 8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 9. PERFORM DIAGNOSTIC SYSTEM CHECK |
| 10. INSPECT SRS WARNING LIGHT |
| 11. ADJUST PARKING BRAKE PEDAL TRAVEL |
Completely release the parking brake pedal.
for TMC, TMMR Made:
![]() |
Loosen the lock nut and the adjusting nut to completely release the parking brake cable.
| *1 | Lock Nut |
| *2 | Adjusting Nut |
for TMMK Made:
![]() |
Remove the lock nut and loosen the adjusting nut to completely release the parking brake cable.
| *1 | Lock Nut |
| *2 | Adjusting Nut |
Remove the rear wheels.
Temporarily install the hub nuts to the hub bolts.
Remove the parking brake shoe adjusting hole plug.
![]() |
Turn the shoe adjuster and expand the shoes until the disc locks.
![]() | Expand |
![]() | Contract |
Turn and contract the shoe adjuster until the disc can rotate smoothly.
Check that there is no brake drag against the shoes.
Install the parking brake shoe adjusting hole plug.
Turn the adjusting nut until the parking brake pedal travel is corrected to be within the specified range.
for TMC, TMMR Made:
Using a wrench or an equivalent tool, hold the adjusting nut and tighten the lock nut.
for TMMK Made:
Using a wrench or an equivalent tool, hold the adjusting nut and install a new lock nut.
Operate the parking brake pedal 3 to 4 times, and check the parking brake pedal travel.
Check that the parking brake does not drag.
Remove the hub nuts from the hub bolts.
Install the rear wheels.
| 12. INSPECT BRAKE WARNING LIGHT |
When operating the parking brake pedal, check that the brake warning light illuminates.