RADIO ANTENNA CORD (for TMMK Made) > INSTALLATION |
| 1. INSTALL NO. 2 ANTENNA CORD SUB-ASSEMBLY |
Apply new double-sided tape.

| *A | w/o Sliding Roof | *B | w/ Sliding Roof |
| *1 | Double-sided Tape | - | - |
| *a | Front | *b | Double-sided Tape Size |
| Area | Dimension |
| A | 1.0 mm (0.0394 in.) |
| B | 10.0 mm (0.394 in.) |
Remove the old double-sided tape from the roof headlining assembly.
Prepare the appropriate amount of new double-sided tape.
Apply the double-sided tape to the roof headlining while aligning the tape with the markings on the roof headlining assembly.
Peel off the release paper from the double-sided tape.
Install the No. 2 antenna cord sub-assembly to the roof headlining assembly from the front of the vehicle.

| *A | w/o Sliding Roof | *B | w/ Sliding Roof |
| *1 | Double-sided Tape | *2 | Tape |
| *3 | Marking Tape | *4 | Protrusion |
| *5 | Adjustment Area | - | - |
| *a | Front | - | - |
Put the strips of tape back to the positions shown in the illustration in order to secure the antenna cord to the roof headlining assembly.
| 2. INSTALL ROOF HEADLINING ASSEMBLY |
| 3. INSTALL ANTENNA CORD SUB-ASSEMBLY |
Engage the 8 clamps to install the antenna cord sub-assembly.
| 4. INSTALL NO. 2 SIDE DEFROSTER NOZZLE DUCT |
![]() |
Engage the 2 claws.
Install the No. 2 side defroster nozzle duct with the screw <C> or <D> or <H>.
| 5. INSTALL NO. 3 HEATER TO REGISTER DUCT |
![]() |
Install the No. 3 heater to register duct with the 3 screws <C> or <D> or <H>.
Install the clip.
| 6. INSTALL INSTRUMENT PANEL SAFETY PAD ASSEMBLY |