Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM

DTC    B1422/22    Compressor Lock Sensor Circuit

for Preparation Click here


SYSTEM DESCRIPTION

The ECM sends the engine speed signal to the air conditioning amplifier assembly via CAN communication.
The air conditioning amplifier assembly reads the difference between compressor speed and engine speed. When the difference becomes too large, the air conditioning amplifier assembly determines that the compressor is locked, and turns the magnetic clutch off.

DTC No.
DTC Detection Condition
Trouble Area
B1422/22
Open or short in A/C lock sensor circuit
  1. Compressor and magnet clutch (A/C lock sensor)
  2. Compressor drive belt
  3. Harness or connector between compressor and magnet clutch (A/C lock sensor) and air conditioning amplifier assembly
  4. Air conditioning amplifier assembly
  5. CAN communication system

WIRING DIAGRAM


E226603E10


INSPECTION PROCEDURE

1.INSPECT COMPRESSOR AND MAGNET CLUTCH (A/C LOCK SENSOR)


    E167398E39
  1. Disconnect the E73 compressor and magnet clutch (A/C lock sensor) connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E73-1 (SSR+) - E73-2 (SSR-)
    20°C (68°F)
    160 to 320 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (Compressor and Magnet Clutch (A/C Lock Sensor))



NG
REPLACE COMPRESSOR AND MAGNET CLUTCH (A/C LOCK SENSOR) (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - COMPRESSOR AND MAGNET CLUTCH (A/C LOCK SENSOR))
  1. Disconnect the I77 air conditioning amplifier assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I77-8 (LOCK) - E73-1 (SSR+)
    Always
    Below 1 Ω
    I77-13 (SG-2) - E73-2 (SSR-)
    Always
    Below 1 Ω
    I77-8 (LOCK) - Body ground
    Always
    10 kΩ or higher
    I77-13 (SG-2) - Body ground
    Always
    10 kΩ or higher


    Result:

    Result
    Proceed to
    NG
    A
    OK (When troubleshooting according to Problem Symptoms Table)
    B
    OK (When troubleshooting according to the DTC)
    C



B
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

C
REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY (Click here)
A

REPAIR OR REPLACE HARNESS OR CONNECTOR