Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING AMPLIFIER (for TMC, TMMR Made)

AIR CONDITIONING AMPLIFIER (for TMC, TMMR Made) > REMOVAL

for Preparation Click here



1. PRECAUTION (for LHD)

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (for LHD)

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE FRONT DOOR SCUFF PLATE

HINT:
Use the same procedure for the RH side and LH side .



4. REMOVE COWL SIDE TRIM SUB-ASSEMBLY

HINT:
Use the same procedure for the RH side and LH side .



5. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP

HINT:
Use the same procedure for the RH side and LH side .



6. REMOVE INSTRUMENT SIDE PANEL

HINT:
Use the same procedure for the RH side and LH side .



7. REMOVE FRONT PANEL GARNISH

HINT:
Use the same procedure for the RH side and LH side .



8. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    B279888
  1. Disengage the 4 claws.

  1. Disengage the 2 guides.

  1. Disconnect the connector to remove the No. 2 instrument panel under cover sub-assembly.



9. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY


    B281767
  1. Remove the bolt <B> and screw <C>.

  1. Open the lower instrument panel door.



    B281768
  1. Remove the 3 screws <C>.



    B281769
  1. Disengage the 2 clips, 4 guides and remove the lower instrument panel sub-assembly as shown in the illustration.



10. REMOVE ECU INTEGRATION BOX RH (for LHD)
w/ ECU Integration Box RH:


11. REMOVE AIR CONDITIONING AMPLIFIER ASSEMBLY
  1. Disconnect each connector.



  1. for LHD:



      E226869
    1. Remove the 2 screws.

    2. Disengage the 2 guides and remove the air conditioning amplifier assembly.



  1. for RHD:



      E228914
    1. Remove the 2 screws.

    2. Disengage the 2 guides and remove the air conditioning amplifier assembly.