TIRE PRESSURE WARNING RECEIVER > INSTALLATION |
| 1. INSTALL TIRE PRESSURE WARNING ECU AND RECEIVER |
![]() |
Connect the connector.
![]() |
Engage the 2 guides and install the tire pressure warning ECU and receiver with the bolt.
| 2. INSTALL ROOF SIDE INNER GARNISH LH |
Install 5 new clips to the roof side inner garnish LH.
Engage the guide.
Engage the 5 clips to install the roof side inner garnish LH.
| 3. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH |
![]() |
Align the alignment mark (Pink) on the weatherstrip with the protruding portion on the vehicle body indicated by the arrow in the illustration, and install the rear door opening trim weatherstrip LH.
| *a | Alignment Mark (Pink) |
| 4. INSTALL REAR SIDE SEATBACK ASSEMBLY LH |
Engage the hook.
Install the rear side seatback assembly LH with the 2 bolts.
Connect the connector.
Connect the rear seat outer belt assembly to the rear seat shoulder belt guide.
| 5. INSTALL REAR SEAT CUSHION LOCK HOOK |
![]() |
Engage the 2 claws to install a new rear seat cushion lock hook as shown in the illustration.
| 6. INSTALL REAR SEAT CUSHION ASSEMBLY |
Place the rear seat cushion assembly in the cabin.
Pass the 2 rear seat inner belt assemblies through the rear seat cushion assembly.
![]() |
Engage the 2 rear seat cushion frame hooks on the front side of the rear seat cushion assembly to the 2 rear seat cushion lock hooks as shown in the illustration.
Confirm that the rear seat cushion assembly is securely installed.
| 7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 8. REGISTER TRANSMITTER ID |
| 9. INSPECT TIRE PRESSURE WARNING SYSTEM |
| 10. PERFORM INITIALIZATION |
| 11. INSPECT SRS WARNING LIGHT |