Home › Vehicle Interior › HEATING / AIR CONDITIONING › COMPRESSOR (for 6AR-FSE)

COMPRESSOR (for 6AR-FSE) > REMOVAL

for Preparation Click here



1. RECOVER REFRIGERANT FROM AIR CONDITIONING SYSTEM
  1. Turn the A/C switch on.

  1. Operate the air conditioning with a set temperature of 25°C (77°F) and the blower at low for 10 minutes to circulate the refrigerant. This causes most of the compressor oil from the various components of the air conditioning system to collect in the air conditioning compressor.

  1. Turn the ignition switch off.

  1. Recover the refrigerant from the air conditioning system using a refrigerant recovery unit.



2. REMOVE RADIATOR ASSEMBLY
(Click here)


3. REMOVE V-RIBBED BELT
(Click here)


4. DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE


    E305922
  1. Remove the bolt.

  1. Disconnect each connector.

  1. Disengage the clamp to disconnect the wire harness.



    E305923
  1. Remove the bolt and disconnect the No. 1 cooler refrigerant discharge hose from the compressor assembly with pulley.

  1. Remove the O-ring from the No. 1 cooler refrigerant discharge hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.



5. DISCONNECT NO. 1 COOLER REFRIGERANT SUCTION HOSE


    E305924
  1. Remove the bolt and disconnect the No. 1 cooler refrigerant suction hose from the compressor assembly with pulley.

  1. Remove the O-ring from the No. 1 cooler refrigerant suction hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.



6. REMOVE COMPRESSOR ASSEMBLY WITH PULLEY


    E305925
  1. Remove the 2 bolts and 2 nuts, and bracket.



    E305926
  1. Using an E8 "TORX" socket wrench, remove the 2 stud bolts and compressor assembly with pulley.

    HINT:
    Remove the compressor assembly with pulley from the vehicle with the stud bolts remaining in the compressor assembly with pulley.