Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM

DTC    U0100    Lost Communication with ECM / PCM "A"

DTC    U0129    Lost Communication with Skid Control ECU

DTC    U0131    Lost Communication with Power Steering Control Module

DTC    U0142    Lost Communication with Main Body ECU

DTC    U0151    Lost Communication with Airbag ECU

DTC    U0163    Lost Communication with Navigation Control Module

for Preparation Click here


DESCRIPTION

The combination meter assembly communicates with the ECM, brake actuator assembly (skid control ECU), power steering ECU with motor assembly, main body ECU (multiplex network body ECU), airbag sensor assembly and navigation receiver assembly* via CAN communication.

DTC No.
DTC Detection Condition
Trouble Area
U0100
When IG voltage is 9.5 V or more and the following condition is detected:
  1. No communication with ECM continues for 2 seconds or more
  1. ECM
  2. CAN communication system
  3. Combination meter assembly
U0129
When IG voltage is 9.5 V or more and the following condition is detected:
  1. No communication with brake actuator assembly (skid control ECU) continues for 2 seconds or more
  1. Brake actuator assembly (skid control ECU)
  2. CAN communication system
  3. Combination meter assembly
U0131
When IG voltage is 9.5 V or more and the following condition is detected:
  1. No communication with power steering ECU with motor assembly continues for 3 seconds or more
  1. Power steering ECU with motor assembly
  2. CAN communication system
  3. Combination meter assembly
U0142
When IG voltage is 9.5 V or more and the following condition is detected:
  1. No communication with main body ECU (multiplex network body ECU) continues for 10 seconds or more
  1. Main body ECU (Multiplex network body ECU)
  2. CAN communication system
  3. Combination meter assembly
U0151
When IG voltage is 9.5 V or more and the following condition is detected:
  1. No communication with airbag sensor assembly continues for 10 seconds or more
  1. Airbag sensor assembly
  2. CAN communication system
  3. Combination meter assembly
U0163*
When IG voltage is 9.5 V or more and the following condition is detected:
  1. No communication with navigation receiver assembly continues for 3 seconds or more
  1. Navigation receiver assembly
  2. CAN communication system
  3. Combination meter assembly
  1. *: w/ Navigation System

INSPECTION PROCEDURE

1.CONFIRM DTC OUTPUT
  1. Check if a CAN communication DTC is output (Click here).

    Result:
    Result
    Proceed to
    CAN communication DTCs are output.
    A
    CAN communication DTCs are not output.
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A

GO TO CAN COMMUNICATION SYSTEM (Click here)