TIRE PRESSURE WARNING RESET SWITCH > INSPECTION |
| 1. INSPECT TIRE PRESSURE WARNING RESET SWITCH |
![]() |
Remove the tire pressure warning reset switch (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 (INT) - 2 (E) | On | Below 1 Ω |
| Off | 10 kΩ or higher |
| *a | Component without harness connected (Tire Pressure Warning Reset Switch) |
| *b | On |
| *c | Off |