WIPER AND WASHER SYSTEM > Speed Signal Circuit |
| for 2GR-FE |

| for 2AR-FE |

| for 6AR-FSE |

| 1.INSPECT COMBINATION METER ASSEMBLY (SPEED SENSOR SIGNAL) |
![]() |
Check the output waveform.
Remove the combination meter assembly with the connector still connected.
Connect an oscilloscope to terminal I18-3 (+S) and body ground.
Turn the ignition switch to ON.
Turn a wheel slowly.
Check the signal waveform according to the condition(s) in the table below.
| Item | Condition |
| Tool setting | 5 V/DIV., 20 ms./DIV. |
| Vehicle condition | Wheel being rotated |
| *a | Component with harness connected (Combination Meter Assembly) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (WINDSHIELD WIPER RELAY ASSEMBLY - COMBINATION METER ASSEMBLY) |
Disconnect the I72 windshield wiper relay assembly connector and I18 combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I72-24 (SPD) - I18-3 (+S) | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (WINDSHIELD WIPER RELAY ASSEMBLY - JUNCTION CONNECTOR) |
Disconnect the I72 windshield wiper relay assembly connector and I124 junction connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I72-24 (SPD) - I124-20 | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||