Home › Vehicle Interior › SEAT › FRONT POWER SEAT CONTROL SYSTEM (w/ Memory)

FRONT POWER SEAT CONTROL SYSTEM (w/ Memory) > Front Power Seat does not Operate with Front Power Seat Switch

for Preparation Click here


DESCRIPTION

Signals are input into the front power seat switch LH (w/ Memory). The built-in ECU manages the signals received from the power seat switch, and operates each motor. If the front power seat switch LH (w/ Memory) receives more than 2 motor operation signals, the motor is stopped. Manual operation is restarted after the front power seat switch LH (w/ Memory) receives 1 signal only.

WIRING DIAGRAM


B270911E44


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK FRONT POWER SEAT OPERATION
  1. Check that each function of the power seat operates normally by using the power seat switch (Click here).

    Result:
    Result
    Proceed to
    All power seat functions do not operate
    A
    One or more power seat functions do not operate
    B



B
GO TO OTHER DIAGNOSIS PROCEDURE (One or more Power Seat Motors do not Operate) (Click here)
A


2.CHECK HARNESS AND CONNECTOR (FRONT POWER SEAT SWITCH LH (W/ MEMORY) - BATTERY)
  1. Disconnect the e11 front power seat switch LH (w/ Memory) connectors.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    e11-7 (+B) - Body ground
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (FRONT POWER SEAT SWITCH LH (W/ MEMORY) - BODY GROUND)
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    e11-2 (GND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE FRONT POWER SEAT SWITCH LH (W/ MEMORY) (Click here)