AIR FUEL RATIO SENSOR > INSTALLATION |
| 1. INSTALL AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1) |
![]() |
Using SST, install the air fuel ratio sensor to the exhaust manifold RH.
| *a | Fulcrum Length 30 mm (1.18 in.) |
| *b | Fulcrum Length 180 mm (7.09 in.) |
Connect the harness clamp.
Connect the air fuel ratio sensor connector.
| 2. INSTALL FRONT EXHAUST PIPE ASSEMBLY |
| 3. INSTALL AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1) |
![]() |
Using SST, install the air fuel ratio sensor to the exhaust manifold LH.
| *a | Fulcrum Length 30 mm (1.18 in.) |
| *b | Fulcrum Length 180 mm (7.09 in.) |
Connect the air fuel ratio sensor connector.
Install the wire harness clamp.
| 4. INSPECT FOR EXHAUST GAS LEAK |
| 5. INSTALL V-BANK COVER SUB-ASSEMBLY |
Fit the 3 retainers and install the V-bank cover sub-assembly.
| 6. INSTALL COOL AIR INTAKE DUCT SEAL |
Install the cool air intake duct seal with the 9 clips.