Home › Engine / Hybrid System ยท 2GR-FE › ENGINE CONTROL › AIR FUEL RATIO SENSOR

AIR FUEL RATIO SENSOR > REMOVAL

for Preparation Click here



1. REMOVE COOL AIR INTAKE DUCT SEAL


    B382622
  1. Remove the 9 clips and cool air intake duct seal.



2. REMOVE V-BANK COVER SUB-ASSEMBLY


    A255420
  1. Hold the front of the V-bank cover sub-assembly and raise it to disengage the 2 retainers on the front of the V-bank cover sub-assembly. Continue to raise the V-bank cover sub-assembly to disengage the retainer on the rear of the V-bank cover sub-assembly and remove the V-bank cover sub-assembly.

    NOTICE:
    Attempting to disengage both front and rear retainers at the same time may cause the V-bank cover sub-assembly to break.



3. REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)


    A255011
  1. Disconnect the air fuel ratio sensor connector.



    A255012
  1. Separate the wire harness clamp.



    A255013E01
  1. Using SST, remove the air fuel ratio sensor from the exhaust manifold LH.

    SST
    09224-00011  



4. REMOVE FRONT EXHAUST PIPE ASSEMBLY
(Click here).


5. REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)


    A255480
  1. Disconnect the air fuel ratio sensor connector.

  1. Disconnect the harness clamp.



    A255015E01
  1. Using SST, remove the air fuel ratio sensor from the exhaust manifold RH.

    SST
    09224-00011