Home › Vehicle Interior › SEAT › REAR SEAT ASSEMBLY (for TMMK Made Fold Down Seat Type)

REAR SEAT ASSEMBLY (for TMMK Made Fold Down Seat Type) > REMOVAL

for Preparation Click here



1. PRECAUTION

CAUTION:
  1. Be sure to read Precaution thoroughly before servicing (Click here).
  2. If the side airbag was deployed, replace the rear seat airbag assembly, rear side seatback frame sub-assembly, rear side seatback cover sub-assembly and rear side seatback pad with the necessary parts in accordance with the extent of the collision damage.

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE REAR SEAT CUSHION ASSEMBLY


    B279202E01
  1. Lift up the front edge of the rear seat cushion assembly as shown in the illustration and disengage the 2 rear seat cushion frame hooks on the front side of the rear seat cushion assembly from the 2 rear seat cushion lock hooks.
    Standard Measurement 
    a
    100 mm (3.94 in.) or less

    NOTICE:
    Be sure to hold the part of the rear seat cushion assembly directly next to the rear seat cushion lock hooks when lifting it up. Lifting a different part of the rear seat cushion assembly may deform the rear seat cushion frame.

  1. Pass the 2 rear seat inner belt assemblies through the rear seat cushion assembly and remove the rear seat cushion assembly.

    NOTICE:
    Be careful not to damage the vehicle body.



4. REMOVE REAR SEAT CUSHION LOCK HOOK


    B393387
  1. Disengage the 2 claws to remove the rear seat cushion lock hook as shown in the illustration.

    NOTICE:
    Rear seat cushion lock hooks must not be reused.

    HINT:
    Use the same procedure for the RH side and the LH side.



5. REMOVE INNER LUGGAGE COMPARTMENT TRIM PAD


    B279201
  1. Remove the inner luggage compartment trim pad.



6. REMOVE REAR SEATBACK ASSEMBLY LH


    B279209E02
  1. Disengage the 2 fasteners as shown in the illustration.
    Text in Illustration 
    *a
    Fastener



    B279211
  1. Remove the 2 bolts and rear seatback assembly LH.

    NOTICE:
    Be careful not to damage the vehicle body.



7. REMOVE REAR SEATBACK ASSEMBLY RH


    B279206E02
  1. Disengage the 3 fasteners as shown in the illustration.
    Text in Illustration 
    *a
    Fastener



    B279208
  1. Remove the 2 bolts and rear seatback assembly RH.

    NOTICE:
    Be careful not to damage the vehicle body.



8. REMOVE REAR SIDE SEATBACK ASSEMBLY LH
  1. Disconnect the rear seat outer belt assembly from the rear seat shoulder belt guide.

  1. Disconnect the connector.



    B285010
  1. Remove the 2 bolts.

  1. Disengage the hook and remove the rear side seatback assembly LH.



9. REMOVE REAR SIDE SEATBACK ASSEMBLY RH
  1. Disconnect the rear seat outer belt assembly from the rear seat shoulder belt guide.

  1. Disconnect the connector.



    B285009
  1. Remove the 2 bolts.

  1. Disengage the hook and remove the rear side seatback assembly RH.