Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for Radio and Display Type)

NAVIGATION SYSTEM (for Radio and Display Type) > Mute Signal Circuit between Stereo Component Amplifier and Telematics Transceiver

for Preparation Click here


DESCRIPTION

The telematics transceiver sends a mute signal to the stereo component amplifier assembly.
The stereo component amplifier assembly controls the volume according to the mute signal from the telematics transceiver.

WIRING DIAGRAM


E262317E99


INSPECTION PROCEDURE

NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System (Click here).

1.INSPECT TELEMATICS TRANSCEIVER


    E353877E06
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    I218-17 (MUTE) - Body ground
    Ignition switch ACC
    Audio system playing
    → Emergency call mode
    2.0 V or higher
    → Below 1 V

    Text in Illustration 
    *a
    Component with harness connected
    (Telematics Transceiver)



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.CHECK HARNESS AND CONNECTOR (STEREO COMPONENT AMPLIFIER ASSEMBLY - TELEMATICS TRANSCEIVER)
  1. Disconnect the I69 stereo component amplifier assembly connector.

  1. Disconnect the I218 telematics transceiver connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I69-24 (TMUT) - I218-17 (MUTE)
    Always
    Below 1 Ω
    I69-24 (TMUT) or I218-17 (MUTE) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT STEREO COMPONENT AMPLIFIER ASSEMBLY
  1. Disconnect the I218 telematics transceiver connector.



    E176650E48
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    I218-17 (MUTE) - Body ground
    Ignition switch ACC
    2.0 V or higher

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Telematics Transceiver)



NG
REPLACE STEREO COMPONENT AMPLIFIER ASSEMBLY (Click here)
OK

REPLACE TELEMATICS TRANSCEIVER (Click here)