Home › Vehicle Interior › SEAT › FRONT SEAT CUSHION HEATER (for TMMK Made)

FRONT SEAT CUSHION HEATER (for TMMK Made) > INSTALLATION

for Preparation Click here


CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The following procedure is for the LH side.



1. INSTALL FRONT SEAT CUSHION HEATER ASSEMBLY


    B405025
  1. Using a tacker, install the front seat cushion heater assembly to the separate type front seat cushion cover with 22 new tag pins.



2. INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER


    B280123
  1. Using hog ring pliers, install the separate type front seat cushion cover to the separate type front seat cushion pad with 12 new hog rings.

    NOTICE:
    1. Be careful not to damage the separate type front seat cushion cover.
    2. Be sure to securely install the hog rings as shown in the illustration while preventing wrinkles from forming on the separate type front seat cushion cover.



3. INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD
  1. Temporarily install the separate type front seat cushion cover with pad.

  1. Engage each hook.



  1. for Driver Side:



      B280171
    1. Install the separate type front seat cushion cover.



  1. for Front Passenger Side:



      B280193
    1. Install the separate type front seat cushion cover.



    B280156E01
  1. Engage the claw (D) and 3 clamps (C) to install the front seat airbag assembly wire harness.

  1. Engage the clamp (B).

  1. Connect the connector (A).

  1. w/ Seat Heater System:

    1. Connect the connector (E).

    2. Engage the clamp (F).



4. INSTALL FRONT SEAT INNER CUSHION SHIELD
  1. Install the front seat inner cushion shield with the 2 screws.

    Torque:
    0.6 N*m{ 6 kgf*cm , 5 in.*lbf }



5. INSTALL FRONT POWER SEAT SWITCH
(Click here)