Home › Vehicle Interior › SEAT › FRONT SEAT CUSHION HEATER (for TMMK Made)

FRONT SEAT CUSHION HEATER (for TMMK Made) > REMOVAL

for Preparation Click here


CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The following procedure is for the LH side.



1. REMOVE FRONT POWER SEAT SWITCH
(Click here)


2. REMOVE FRONT SEAT INNER CUSHION SHIELD


    B280170
  1. Remove the 2 screws and front seat inner cushion shield.



3. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD


    B280156E01
  1. Disconnect the connector (A).

  1. Disengage the clamp (B).

  1. Disengage the claw (D) and 3 clamps (C) to separate the front seat airbag assembly wire harness.

  1. w/ Seat Heater System:

    1. Disconnect the connector (E).

    2. Disengage the clamp (F).



  1. for Driver Side:



      B280171
    1. Separate the separate type front seat cushion cover.



  1. for Front Passenger Side:



      B280193
    1. Separate the separate type front seat cushion cover.



    B269641
  1. Disengage the 4 hooks.



    B280172
  1. Disengage each hook and remove the separate type front seat cushion cover with pad.



4. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER


    B280122
  1. Remove the 12 hog rings and the separate type front seat cushion cover from the separate type front seat cushion pad.



5. REMOVE FRONT SEAT CUSHION HEATER ASSEMBLY


    B405025
  1. Remove the 22 tag pins and the front seat cushion heater assembly from the separate type front seat cushion cover.