Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › FRONT SPEED SENSOR

FRONT SPEED SENSOR > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The following procedure is for the LH side.
  3. If the sensor rotor needs to be replaced, replace the front drive outboard joint shaft assembly.



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE FRONT WHEEL


4. REMOVE FRONT FENDER LINER

HINT:
Use the same procedure for the RH side and LH side .



5. REMOVE FRONT SPEED SENSOR


    C238451
  1. Disconnect the connector and disengage the clamp.



    C238450
  1. Remove the bolt and front speed sensor clamp from the body.



    C238449E01
  1. Remove the bolt, front flexible hose and front speed sensor clamp together from the shock absorber assembly.
    Text in Illustration 
    *1
    Front Speed Sensor Clamp
    *2
    Front Flexible Hose

  1. Disengage the clamp from the front shock absorber assembly.



    C238448
  1. Remove the bolt and front speed sensor from the steering knuckle.

    NOTICE:
    1. Prevent foreign matter from attaching to the front speed sensor tip.
    2. Clean the speed sensor installation hole and the contact surfaces every time the front speed sensor is removed.