REAR SPEED SENSOR (for TMMK Made) > INSTALLATION |
| 1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY |
Install the rear axle hub and bearing assembly .
| 2. INSPECT REAR AXLE HUB BEARING LOOSENESS |
![]() |
Using a dial indicator, check for looseness near the center of the rear axle hub.
| 3. INSPECT REAR AXLE HUB RUNOUT |
![]() |
Using a dial indicator, check for runout on the surface of the rear axle hub outside the rear axle hub bolts.
| 4. CONNECT SKID CONTROL SENSOR WIRE |
Connect the connector to the rear speed sensor.
| 5. INSTALL REAR DISC |
![]() |
Align the matchmarks of the rear disc and rear axle hub, and install the rear disc.
| *a | Matchmark |
| 6. INSTALL PARKING BRAKE SHOE ADJUSTING HOLE PLUG |
Install the parking brake shoe adjusting hole plug.
| 7. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY |
Install the rear disc brake caliper assembly with the 2 bolts.
Install the rear flexible hose to the rear shock absorber assembly with the bolt.
| 8. ADJUST PARKING BRAKE |
| 9. INSTALL REAR WHEEL |
| 10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 11. CHECK FOR SPEED SENSOR SIGNAL |