Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM

DTC    C1621    Back Camera Power Supply Failure

for Preparation Click here


DESCRIPTION

This DTC is stored if the rear television camera assembly judges as a result of its self check that the signals or signal lines between the rear television camera assembly and radio and display receiver assembly are not normal.

DTC No.
DTC Detection Condition
Trouble Area
C1621
Rear television camera assembly power supply failure
  1. Harness or connector
  2. Rear television camera assembly
  3. Radio and display receiver assembly

WIRING DIAGRAM


E288974E19


INSPECTION PROCEDURE

NOTICE:
  1. If the cable was disconnected from and reconnected to the negative (-) battery terminal, the estimated course lines may not be displayed on the image of the area behind the vehicle. In this case, perform "Correct the Steering Angle Neutral Point" (Click here).
  2. Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (Click here).

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - REAR TELEVISION CAMERA ASSEMBLY)
  1. Disconnect the I185 radio and display receiver assembly connector.

  1. Disconnect the T20 rear television camera assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I185-11 (CA+) - T20-6 (CB+)
    Always
    Below 1 Ω
    I185-23 (CGND) - T20-5 (CGND)
    Always
    Below 1 Ω
    I185-11 (CA+) - I185-23 (CGND)
    Always
    10 kΩ or higher
    I185-11 (CA+) - Body ground
    Always
    10 kΩ or higher
    I185-23 (CGND) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT RADIO AND DISPLAY RECEIVER ASSEMBLY (CA+)
  1. Reconnect the I185 radio and display receiver assembly connector.



    E289196E25
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    I185-11 (CA+) - Body ground
    Ignition switch ACC
    5.5 to 7.05 V

    Text in Illustration 
    *a
    Component with harness connected
    (Radio and Display Receiver Assembly)



NG
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)
OK

REPLACE REAR TELEVISION CAMERA ASSEMBLY (Click here)