DTC C1428 Motor Circuit Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1428 | A malfunction occurs in the pump motor circuit. | Pump motor circuit |
| 1.CHECK HARNESS AND CONNECTOR (+BM TERMINAL) |
![]() |
Make sure that there is no looseness at the locking part and the connecting part of the connector.
Disconnect the skid control ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A49-1 (+BM) - Body ground | Always | 11 to 14 V |
| *a | Front view of wire harness connector (to Skid Control ECU (Brake Actuator Assembly)) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (GND2 TERMINAL) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A49-13 (GND2) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to Skid Control ECU (Brake Actuator Assembly)) |
|
| ||||
| OK | |
| 3.RECONFIRM DTC |
Reconnect the skid control ECU connector.
Clear the DTCs (Click here).
Turn the ignition switch off.
Start the engine.
Perform a road test.
Check if the same DTC is output (Click here).
| Result | Proceed to |
| DTC C1428 is not output. | A |
| DTC C1428 is output. | B |
|
| ||||
| A | ||
| ||